Note: If using Microsoft IIS you need to add. A Web Server, (or FTP server) setup, with the files above available for ‘download’ into the FirePOWER module.A Firepower Software Package (i.e. asasfr-sys-6.0.0-1005.pkg) this is a BIG file (over a Gigabyte) – download from Cisco.This process works on the ‘baby ASA’s,’ i.e 5506-X and 5508-X, and also on the larger models i.e 5512-X upwards (but NOT the 5585-X, that has a hw-module not a sw-module). Normally I only have to do this if something’s gone wrong, and I can’t contact the module, or I’ve go a lot of them to do, and I don’t have direct management access. Note: This ASDM upgrade will fail if the module is being managed by the FirePOWER Management center (FireSIGHT), you can update it from there, or remove the peer association, then update it. See Updating FirePOWER Module (From ASDM) The process is a LOT EASIER to do in the ASDM, I’m not usually an advocate of the GUI, but if you can access the FirePOWER settings that way, it will do all the hard work for you, (see below). (Remember if you set the FirePOWER module to ‘fail-closed’, you will lose internet access, so you might want to change that to ‘fail-open’ as well). This takes ages! Seriously, if it’s late in the afternoon you might want to do this tomorrow morning, or leave the re-imaging running overnight.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |